Waterproofing Installation in Ft Worth area - Decks, Balconies, Basements, Custom Work
New Construction, Finished Deck System
Flashings and installation of our product is the same as the finished deck system except that after the Second Layer is troweled on, tile or slate may be thin set directly to the new surface.
Covering Existing Concrete
Concrete does not allow for use of the Metal Lathing, so a Polypropylene Mesh is used instead.
- 6" X 6" Galvanized Wall Flashings installed and set in our product at all wall abutments.
- 3" edge metal set in our product on the perimeters of the balcony/deck.
- Door Pans installed at each door opening.
- A layer of our product is troweled over the flashings and set in a bed of reinforcing metal lathing with no color added.
- The Second Layer again is troweled on without color on the second day. The balcony/deck is fully waterproof after the second layer has dried.
- Once all trades are finished, the Third Layer is installed with the selected color using a hopper to acquire the desired texture.
- Finally, a roll-on Color Layer of the same polymer is applied with a High Traffic Clear Seal Coat.
- New Construction, Waterproof Mud-Bed for Tile
Flashings and installation of our product is the same as the finished deck system except that after the Second Layer is troweled on, tile or slate may be thin set directly to the new surface.
Covering Existing Concrete
Concrete does not allow for use of the Metal Lathing, so a Polypropylene Mesh is used instead.
- Concrete walls may be flashed using the Poly-mesh product running up the concrete wall at least 6 inches.
- If the concrete walls present a potential leak situation, the poly-mesh will continue up and under the next available waterproof exterior, or proceed up and over the concrete wall to completely seal it off.
- The Poly-Mesh will be rolled out on the concrete and the first layer of our product, using no color, will be troweled on and imbedded into the mesh, adhering it to the concrete deck.
- A second layer of our product will be troweled on, again using no color.
- Once dry, the blown on knocked down texture layer, with color added, is applied.
- Finally, the roll-on color layer is applied along with the High Traffic Clear Seal Coat.